The Call We Get After Every Storm
Spring storm season rolls through Maury and Williamson counties, the power drops, and the phone starts ringing: "The power is out and my generator never started." It is the most frustrating call in this trade, because the whole point of the machine is that one moment. The good news is that most no-start failures come from a short list of causes, and most of them are preventable.
Why Generators Fail to Start
Nine times out of ten it is the battery: dead, corroded, or simply too old to crank the engine. After the battery come stale fuel and clogged filters on portable units, a disabled or failed exercise cycle on standby units, and transfer-switch faults that leave the generator running with no power reaching the house. We test in that order, battery first, so you do not pay for parts you do not need. Most of these repairs land in our typical $100-$300 range; a transfer switch replacement runs higher, and we quote it upfront.
Exercise Cycles: The Feature People Forget
Standby generators are supposed to run a short weekly self-test, usually 10 to 12 minutes. That exercise cycle keeps the engine limber, charges the battery, and, just as importantly, tells you something is wrong while the weather is still nice. If you notice the exercise has not run in weeks, or the controller is showing a fault you have been ignoring, that is the generator asking for help. Do not wait for the next storm to find out what it wanted.
Transfer Switch Issues
Sometimes the generator runs perfectly and the house stays dark. That is a transfer switch problem: the switch that moves your home from utility power to generator power is stuck, has pitted contacts, or lost its control signal. Symptoms include the generator running with no power inside, partial power (some circuits live, others dead), or a chattering sound from the switch enclosure. Transfer switches involve utility-level voltage, so this is firmly professional-only work.
A Maintenance Schedule That Actually Works
| When | What to do |
|---|---|
| Monthly | Confirm the exercise cycle ran. Glance at the controller for fault codes or warnings. Clear debris, nests, and vegetation from around the unit. |
| Each season | Check battery terminals for corrosion and tightness. Check oil level. For portables, rotate stored fuel or add stabilizer. |
| Yearly | Full service: oil and filter change, air filter, spark plug, battery load test, and a proper load test to prove it carries the house. |
| Every 2 - 3 years | Replace the battery proactively, even if it still cranks. Batteries are the number one no-start cause, and age kills them quietly. |
Generac's support resources are useful if you want model-specific maintenance schedules for the most common standby brand we see.
Storm-Ready in Spring Hill
We service standby and portable generators across Spring Hill, from Buckner Crossing to Harvest Point. If your generator sat silent through the last outage, call Quick Air Fix before the next storm line forms over the Tennessee River valley. Finding the problem on a calm Tuesday beats finding it in the dark. The same storm that silences a generator can fry appliance control boards too: if your fridge or washer acted up after the outage, our refrigerator repair team can help, and a dead thermostat after a surge can mimic equipment failure (see thermostat repair).
Generator Silent When the Power Went Out?
Most repairs between $100 and $300 for most common repairs. Free estimates and upfront pricing before any work starts.
What to Expect When You Book
No fine print, no surprises. Here is exactly how a service call with us goes.
- Call (931) 208-9792. Tell us what is happening in one sentence. We will ask two or three quick questions so the tech shows up with the right parts.
- Get a visit, typically same-day or next-day. We serve all of Spring Hill, on both the Maury County and Williamson County sides.
- Free estimate, firm price first. We diagnose the problem and give you an upfront price before any work starts. You approve it or you do not. Most repairs land between $100 and $300.
- We fix it and test it. We run the appliance through a full cycle before we leave, and we clean up after ourselves.
Our hours are Mon-Fri 7AM-7PM, Sat 8AM-4PM, Sun closed. If you are not sure whether it is worth fixing, read our repair vs replace guide or just call and ask. We would rather give you a straight answer than sell you a repair you do not need.
Frequently Asked Questions
Why won't my generator start after a power outage?
The most common cause is a dead or weak battery, followed by stale fuel or clogged filters on portables, and a disabled exercise cycle on standby units. We test the battery first, then fuel and ignition, then the starting circuit, so the diagnosis stays cheap and logical.
How often should my standby generator run its exercise cycle?
Weekly, for about 10 to 12 minutes, is the common factory default. That short run keeps the engine healthy, keeps the battery charged, and surfaces faults while the weather is calm. If yours has stopped exercising, or the controller shows a fault, get it checked before storm season.
My generator is running but my house has no power. What's wrong?
That points to the transfer switch: the component that moves your home from utility power to generator power. It may be stuck, have damaged contacts, or have lost its control signal. Transfer switches carry utility-level voltage, so this needs a professional. Do not open the enclosure yourself.
How often does a generator need maintenance?
At minimum, a full service once a year: oil, filters, spark plug, battery test, and a load test. Batteries should be replaced proactively every two to three years. Monthly, just confirm the exercise cycle ran and clear debris from around the unit.
Do you service generators in Buckner Crossing and across Spring Hill?
Yes, we service standby and portable generators throughout Spring Hill, including Buckner Crossing, Harvest Point, and both the Maury and Williamson County sides of town. Storm-season calls get priority scheduling.
Related Services
AC Repair
AC not cooling? Capacitors, leaks, and electrical faults fixed.
Thermostat Repair
Blank screen or wrong temps? Thermostat and wiring repair.
We Service All Major Appliance Brands
We repair appliances from all the major manufacturers, including GE, Samsung, Whirlpool, LG, KitchenAid, Frigidaire, Kenmore, Maytag, Bosch, Amana, Electrolux, Hotpoint, and Roper. See all brands we service.
Get in Touch with Quick Air Fix
Call or text is the fastest way to reach us. Tell us what is going on and we will get you scheduled.
Quick Air Fix
-
Phone
(931) 208-9792 -
Address
5075 Main St, Spring Hill, TN 37174
-
Hours
Mon-Fri: 7AM - 7PM
Sat: 8AM - 4PM
Sun: Closed